Working With Our Resin Parts

Our parts are printed in resin, then washed and fully UV-cured before they ship. Cured resin is a hard, stable plastic and is safe to handle. Finishing the parts still involves cutting and sanding, so please follow a few simple precautions.

Removing supports

Many of our parts ship with their print supports still attached. Cut the supports off carefully with a good, sharp sprue cutter, taking small bites close to the part rather than twisting or snapping them off.

Wear eye protection. Cured resin is hard and brittle, and small, sharp chips can fly off when supports are cut.

Cleaning up and sanding

Where the supports were attached, you may find small bumps. Sand or file them smooth for the best fit.

Keep the dust down. Fine resin dust can irritate your nose, throat and lungs. We recommend:

  • Wear a dust mask while sanding. An N95 or better gives the best protection, since loose cloth or surgical masks don’t stop fine dust.
  • Wet-sand when you can, or wipe parts and your work surface with a damp paper towel as you go, so the particles don’t become airborne.
  • Wash your hands with soap and water when you’re finished, and don’t eat or drink while you work.

Gluing

ACC (CA) glue works well with all our resin parts.

Priming and painting

All parts come unpainted. They take paint well once primed. We recommend Mr. Surfacer 1000 or Tamiya Surface Primer, but any good, thin primer will work.

Parts exposed to sunlight must be primed and painted. Sunlight keeps curing the resin, and over time unprotected parts can become brittle. Normal indoor fluorescent and LED lighting is not an issue.

Paint also protects parts that get handled often, like rolling stock and figures.

Please do not eat our products as they are NOT food safe.