Caboose Steps B

$5.99

Caboose 2 steps with holes. Standard caboose steps, holes in steps.  2” 9” wide. Set of four for one caboose.

  • Many of our parts come with supports still attached, and will need to be carefully cut. We always recommend a good sprue cutter for this. Some minor sanding may be required. Parts that have had their supports removed may have some small bumps where the supports were removed that will need to be sanded/filed off for a better fit.
    ACC glue works well for all our resin parts.
    Parts take paint well after priming. We recommend Mr. Primer Surfacer 1000, but any good thin primer will work.
    All parts come unpainted.
SKU: CS2 Category:

Related products

  • Grab Iron Ends (Rivet): O Scale

    These small parts will really dress up older Athearn/Reynolds/AllNation cars as well as some new cast cars, and of course, your custom built equipment. These represent the Rivet design that attached a hand grab to newer metal cars.

    The stem is .020 and designed for .015 wire. There are 17 parts per sprue and four sprues per package.

    Many of …

    $3.95

  • Air Hose w/Angle Cock & Glad Hand: O Scale

    This resin has some flex and will not crack when pressure is applied. These take paint well after priming. We normally use Mr. Primer Surfacer 1000, but any good thin primer will work.
    12 pieces per package or enough for 6 cars / locomotives.

    NOTE: This is NOT offered in black resin because to add any type of rust color to the …

    $3.95

  • Grab Iron Double Nut/Bolt for Caboose: O Scale

    This is a double Nut/Bolt grab iron end used on many cabooses. See image. May other uses as well such roof top grabs.
    The stem is .020 and designed for .015 wire. There are 17 parts per sprue and four sprues per package.

    • Many of our parts come with supports still …

    $3.95

  • Grab Iron Ends (Nut/Bolt): O Scale

    These small parts will really dress up older Athearn/Reynolds/AllNation cars as well as some new cast cars, and of course, your custom built equipment. These represent the Nut/Bolt that attached a hand grab to a car. The bolt is a scale 5/8″ with the nut 1/8″.

    The stem is .020 and designed for .015 wire. There are 17 parts per sprue …

    $3.95