BUDA No. 30 Clamp Type Steel Bumping Post: S Scale
$7.95
The Buda No. 30 track bumper was used on North American railroads. They could be found all over, on customer sidings, yards and more. Our kit includes the clamping parts to attach to the rail. Designed for code 100 track, however, larger codes may be used by removing or filing the pieces. Once glued and ballasted in place you will not notice the difference.
Parts come on supports and will need to be carefully cut. We always recommend a good sprue cutter for this. Some minor sanding may be required.
Check out the PDF below for drawings and a BUDA diagram.
Buda Number 30 Drawings- Many of our parts come with supports still attached, and will need to be carefully cut. We always recommend a good sprue cutter for this. Some minor sanding may be required. Parts that have had their supports removed may have some small bumps where the supports were removed that will need to be sanded/filed off for a better fit.
ACC glue works well for all our resin parts.
Parts take paint well after priming. We recommend Mr. Primer Surfacer 1000, but any good thin primer will work.
All parts come unpainted.
Related products
-
K Brake 8 Inch: S Scale
New item from the best artwork available. This is the 8 inch version suited for narrow gauge equipment. Two in a package.
These parts were water cured for best durability.
- Many of our parts come with supports still attached, and will need to be carefully cut. We always recommend a good …
- Many of our parts come with supports still attached, and will need to be carefully cut. We always recommend a good …
-
Alco Models Gearbox
This item is based on an article in the April/May issue of The S Scale Resource Magazine written by Chris Rooney. These parts will be printed on demand and will take a two week lead time.
In the early 1980’s Alco Models produced a line of very welcome brass diesel models for S scale – specifically 1981 Alco …
-
K Brake 10 Inch: S Scale
New item from the best artwork available. This is the 10 inch version suited for 80,000 pound cars. Two in a package.
These parts were water cured for best durability.
- Many of our parts come with supports still attached, and will need to be carefully cut. We always recommend a good …
- Many of our parts come with supports still attached, and will need to be carefully cut. We always recommend a good …
-
AB Brake 3 Piece Set: S Scale
New item from the best artwork available. Note that the air reservoir and brake cylinder will come on supports and will need to be carefully cut. We always recommend a good sprue cutter for this. The AB valve sprue was removed pre curing as to not remove the more delicate parts. Some minor sanding may be required.
These parts were water …