Shop

Showing 9–16 of 28 results

  • Grab Iron Double Nut/Bolt for Caboose: O Scale

    This is a double Nut/Bolt grab iron end used on many cabooses. See image. May other uses as well such roof top grabs.
    The stem is .020 and designed for .015 wire. There are 17 parts per sprue and four sprues per package.

    • Many of our parts come with supports still …

    $3.95

  • Grab Iron Ends Square Nut: O Scale

    These small parts will really dress up older Athearn/Reynolds/AllNation cars as well as some new cast cars, and of course, your custom built equipment. These represent the square nut that attached a hand grab to older wooden cars. The bolt is a scale 5/8″ with the nut 1/8″.

    The stem is .020 and designed for .015 wire. There are 17 parts …

    $3.95

  • Deco Box Car Ends: O Scale

    These distinctive ends were used by the C&O and the B&O. Our ends are sized to fit O-Scale InterMountain 1937 AAR box cars.
    Two per package.

    The instructions below show the end being mounted on an An S Scale America 1937 AAR Box Car. The process in the same for the O Scale InterMountain 1937 AAR Box Car.

    The S Scale version is …

    $6.95

  • MU Housings: O Scale

    Based on manufacturer’s drawings. You will receive 8 assemblies, enough for two locomotives.  They can be bolted onto the locomotive itself or using some type of easy to make bracket. The bracket is up to you. A few bits of brass or styrene, and you’re  done.

    • Many of our parts …

    $4.95

  • K Brake 10 Inch: S Scale

    New item from the best artwork available. This is the 10 inch version suited for 80,000 pound cars. Two in a package.

    These parts were water cured for best durability.

    • Many of our parts come with supports still attached, and will need to be carefully cut. We always recommend a good …

    $3.95

  • AB Brake 3 Piece Set: S Scale

    New item from the best artwork available. Note that the air reservoir and brake cylinder will come on supports and will need to be carefully cut. We always recommend a good sprue cutter for this. The AB valve sprue was removed pre curing as to not remove the more delicate parts. Some minor sanding may be required.

    These parts were water …

    $3.95

  • RGS Relay Cabinet #2 Kit: O Scale

    From the catalogs of the General Railway Supply Company these type of cabinets go back to at least the 1920’s. Used alone for track circuits or crossing and train signals, they were used all over and many can still be seen today. Tall version single door.

    There may be some minor sanding needed on the parts. We removed all the supports, …

    $9.95

  • Grab Iron Double Rivet for Caboose: O Scale

    This is a double rivet grab iron end used on many cabooses. See image. May other uses as well such roof top grabs.
    The stem is .020 and designed for .015 wire. There are 17 parts per sprue and four sprues per package.

    • Many of our parts come with supports still …

    $3.95